Chapter 2
Installation and Setup
2-4
STB-4000 User Guide
Connect the STB-4000 to Power
Perform the following steps to connect the STB-4000 to the 5V DC power supply.
Note:
Use cabling long enough to avoid placing stress on the input or output connections.
1. Connect the 5V DC supply to the wall outlet.
2. Connect the DC supply barrel plug to the power input on the left side of the STB-4000’s rear panel as
shown below:
3. Wait for the unit to go through its boot process. This can take up to 3 minutes to complete. When the
boot process completes, you will see a splash screen on the TV.
Note:
If this screen does NOT appear, unplug power, wait 5 seconds and plug it back in. If the unit
does not show the splash screen after 3 minutes, call Support at 1-888-860-6090.
4. Continue to the next section.