30
10.2.2 Monthly
• Spray WD-40 on the handlebar adjustment mechanism for smooth adjustments.
• Check the grip surface under the pad holder if it still has sufficient grip for the pad.
• Check the vibration rubbers for tears.
10.2.3 Yearly
• Make sure that the mandatory - Occupational Health and Safety Act
- safety inspection (NEN 3140) for electrical tools is done.
Tightening torques for bolts:
M8x1,25-8.8
25 Nm
M10x 1,5-8.8
50 Nm
M12x1,75-8.8
90 Nm
M16x2,0-8.8
220 Nm
10.3 Pad replacement
If the working speed reduces, or the result becomes less, then
the pad may be severely soiled or worn and should be replaced.
The pad is attached to the eccentric plate with Velcro.
Do the following steps:
• Turn off the machine.
• Remove the plug from the socket.
• Remove the waste water tank.
• Remove the clean water tank.
• Set the handle with T-handlebar to the highest position.
• Tilt the machine backwards so that the handlebar is on the floor and the pad is vertical.
• Pull the pad from the eccentric plate.
• Attach the new pad carefully to the eccentric plate and then push it firmly in place.
• Put the machine in upright position again.
• Fit both tanks on the machine.
• Put the plug in the socket.
• Release the handle.
• Turn the machine on and you are ready to work again.
11. MALFUNCTIONS
1. The machine does not start:
• Check the earth leakage circuit breaker.
• Check the power supply.
• Check the cables for damage.
• Contact your supplier.
