11
DRAINAGE
During the process of cooling, some water will be extracted from the air into the unit.
If the reservoir is full, both
of the compressor and motor will stop and the units would
buzz (you can press any button to stop the buzz). The Full Water indicator will flash to
show you.
To make the cooling work again, please empty the water by one of the following ways:
1.
Turn off the air conditioner and
avoid moving it when full.
2. Position a container (a water tray for
example) underneath the drain hole.
3. Remove the drain knob & rubber
plug from the drain hole and allow
the water to drain out.
4.
When the container is almost full,
replace the rubber plug in the drain
hole and empty the water tray.
5.
Repeat until the unit is emptied.
6. Replace the rubber plug and tighten
the drain knob firmly.
7. Switch on the unit - the full water or
compressor operating indicator
should not be flashing.
FIG.18
If you wish to operate the unit without the need to empty the water tank, please:
•
Remove the drain knob and
rubber plug and retain for future
use.
•
Connect the drain tube supplied
to the water outlet as shown and
locate the other end into a drain.
FIG.19
Water hole
Rubber
plug
Drain knob
