Page | 4
§
To avoid burns, do not touch the appliance surface by hand and other body
parts. It is also necessary to avoid touching the heater whilst the appliance
is switched on, as severe burns may result. The appliance can take up to 1
hour to cool down after switching it off.
§
Do not place any items of clothing, hand towels or similar over the heater to
dry. Risk of overheating and fire hazard.
§
Do not leave the heater unattended whilst in use.
§
Do not use this heater on a wet surface, or where it can fall or be pushed
into water.
§
Do not reach for an appliance that has fallen into water. Switch off at supply
and unplug immediately.
§
If the heater is defective, it must be returned to the place of purchase.
§
Do not operate appliance with wet hands.
§
Use this appliance only as described in this manual. Any other use is not
recommended by the manufacturer and may cause fire, electric shock or
injury.
§
Do not use abrasive cleaning products on this appliance. If the body
becomes dirty, wipe off dust with a cloth, and the radiating boards should be
wiped when they are cold with a damp soft cloth. Always remove plug from
the mains supply before cleaning.
§
The heater must be installed at least 2.4 m above the floor.
§
The heater must not be located immediately below a socket-outlet. The
heater must not be located in front of a socket-outlet. They should be located
outside the physical footprint of the units to minimize heat build-up behind
the heater.
§
The installation must be equipped with a standard electrical power point with
a break contact distance of at least 3mm. The standard power point must be
installed by a licensed electrician.
§
If the heater is to be mounted on an incline (eg. Sloping or angled ceiling),
ensure the electrical connection is located at that lowest point of the heater.
§
Do not connect the appliance to the mains source until it has been installed
in its final location and adjusted to the position it will be used in.
