17
installer Programmable Features (cont’d)
Feature #6 - engine Detection method
Tachless Hi
(press “
lock
” button to program)
- DeFaulT
Tachless lo
(press “
unlock
” button to program)
Tach Wire
(press “
trunk
” button to program)
Data Tach
(press “
start
” button to program)
Crank Only
(press “
lock
” & “
unlock
” to program)
This feature selects the method in which the remote start monitors the engine’s running condition
in remote start mode�
“Tachless Hi”
sensitivity mode uses a preset crank time (see installer feature #7) and monitors
the vehicle’s voltage level to determine if the engine is running� This setting looks for a voltage
increase of 0�3v after cranking�
“Tachless lo”
sensitivity mode operates like the “Tachless Hi” setting but looks for a voltage
increase of 0�5v after cranking�
“Tach Wire”
Before this setting is programmed, refer to the “Violet/White wire” section of the
installation manual for proper wiring connection and the Tach Learn Procedure� It will crank the
engine for up to 3 seconds or until a tach signal is detected�
“Data Tach”
mode operates just like the “Tach Wire” setting except it takes its reading from the
D2D data port instead of using the Violet/White wire� Before using, make sure this function is sup-
ported by the Databus Interface module�
“Crank Only”
AKA “blind start” is similar to the “Tachless” settings however, it only makes one
start attempt and does not monitor engine running conditions� This is useful for many “push-to-
start” vehicles�
Feature #8 - PinK/WHiTe (ign #2)Wire Function
ignition
(press “
lock
” button to program)
- DeFaulT
accessory
(press “
unlock
” button to program)
Starter
(press “
trunk
” button to program)
This feature changes the operation of the unit’s large PINK/WHITE output wire�
This feature
should only be programmed by the installer
�
Feature #7 - Starter Cranking Time
0.75 Second
(press “
lock
” button to program)
- DeFaulT
1.00 Second
(press “
unlock
” button to program)
1.5 Seconds
(press “
trunk
” button to program)
2.25 Seconds
(press “
start
” button to program)
This feature determines the crank time of the 1st start attempt when in “Tachless” mode� If the
engine doesn’t start on the first attempt, it will retry up to 3 more times extending the crank time by
an additional 0�2 second with each attempt��
Feature #9 - Oem arm/Disarm Outputs or additional Channels
Oem arm / Oem Disarm
(press “
lock
” button to program)
- DeFaulT
Oem arm / Channel 5
(press “
unlock
” button to program)
Channel 4 / Oem Disarm
(press “
trunk
” button to program)
Channel 4 / Channel 5
(press “
start
” button to program)
The system has outputs designed for arming and/or disarming a factory-equipped security system.
These wires may be used instead to provide further system outputs, which are remotely operated
by the controller or transmitter� These outputs are in addition to the 2nd channel and 3rd channel
outputs� As shown in the programming assignment, the arm, disarm, channel 4 and channel 5 are
programmable as various combinations� For example, if the disarm output is needed, but not the
arm output, then channel 4 may be made available for use�
