5
BLACK/WHITE WIRE - NEUTRAL SAFETY (-) INPUT
REQUIRED�
This input is a critical safety circuit which allows remote start opera-
tion whenever the gear selector is in park or neutral (automatic transmission), or
when the parking brake is applied (manual transmission)� Remote start will not oper-
ate unless this wire sees chassis ground�
CONNECTION (Automatic Transmission):
Connect this to the neutral safety
switch wire that shows (-) ground when the gear selector is in the park and neutral
positions�
CONNECTION (Manual Transmission):
Connect this to the parking brake switch
wire that shows (-) ground when the parking brake is applied�
14 Pin Secondary Wire Harness (cont’d)
VIOLET/WHITE WIRE - TACH SIGNAL INPUT
This input provides the engine’s RPM signal to the remote start� This is typically
the most reliable form of engine detection� To use the tach wire, you must change
installer feature #3 to the tach wire setting�
CONNECTION:
This can be connected to any trigger wire for an ignition coil, fuel in-
jector, or the signal to the tachometer in the dash� Use a digital multimeter set for AC
volts to test� The appropriate wire will read between 1-6 volts AC and will increase
as the engine RPM increases�
BROWN WIRE - HORN (-) OUTPUT
This output provides a 1 amp negative output to operate the vehicle’s horn�
CONNECTION:
Connect this wire to the vehicle’s horn circuit� If the vehicle’s circuit
is something other than negative, you will need to use a relay to convert this output�
WHITE WIRE - FLASHING LIGHT (+) OUTPUT
This output provides a 10 amp positive output to flash the vehicle’s parking lights
(typically)� If the vehicle has a low current negative parking light circuit, use the
WHITE/BLACK wire instead�
CONNECTION:
Connect this wire to the vehicle’s positive parking light circuit� It will
show +12 volts when the parking lights are on�
BE SURE NOT TO CONNECT TO
THE DIMMER CIRCUIT WHICH WILL CHANGE VOLTAGE AS YOU TURN THE
DIMMER KNOB�
WHITE/BLACK WIRE - FLASHING LIGHT (-) OUTPUT
This output provides a 250mA negative output to flash the vehicle’s parking lights.
If the vehicle has a positive parking light circuit, use the WHITE wire instead�
CONNECTION:
Connect this wire to the vehicle’s negative parking light circuit� It
will show ground when the parking lights are on�
BE SURE NOT TO CONNECT TO
THE DIMMER CIRCUITWHICH WILL CHANGE RESISTANCE TO GROUND AS
YOU TURN THE DIMMER KNOB�
GRAY WIRE - HOOD TRIGGER (-) INPUT
REQUIRED�
This is a critical safety circuit that prevents remote start functions
while the hood is opened� It also monitors the doors in manual transmission mode�
CONNECTION:
Connect this wire to the OEM hood switch or light� It will show
ground when the hood is opened� You can also use the included pin switch�
(continued on page 8)
