Controller Functions (cont’d)
TRUNK RELEASE / CHANNEL 2:
Press the LOCK & START buttons
for 3 seconds�
• THE SYSTEM WILL UNLOCK/DISARM AND THE TRUNK
WILL OPEN (IF EQUIPPED)�
1-BUTTON REMOTE: NOT AVAILABLE
REMOTE START:
Press and release the START button twice within 5
seconds (see user feature #8 to change)�
• THE PARKING LIGHTS WILL FLASH ONCE AND THE
STATUS LIGHT WILL FLASH RAPIDLY�
• THE SYSTEM WILL PROCEED TO START THE ENGINE�
• ONCE THE ENGINE IS RUNNING, THE PARKING LIGHTS
WILL TURN ON AND THE STATUS LIGHT WILL FLASH
SLOWLY�
• If the engine stalls, the system will make up to 3 more attempts�
• Each time you park, set the climate controls to give you the desired interior
temperature when you use the remote start�
• The engine will run for the preset run time (see user feature #1)�
• Run Time Extender
: Press the START button one time during remote start to
restart the engine run timer� The timer will restart�
NOTE: This can only be used once per remote start cycle.
• If you decide not to drive your vehicle, you can turn off the remote start using the
same method to turn it on (Default = press START twice in 5 seconds)�
NOTE: If user feature #8 is programmed for 1 press, the 1st press = Run Time Extender so an
additional press is required.
• Upon entering the vehicle during remote start mode, turn the ignition key to the
“ON/RUN” position (
NOT START!!
)� When you press the brake pedal, the remote
start will turn off allowing the ignition key to take over�
x2
4
