12
13
Special Care & Handling
• Always turn off the flashlight when charging.
• Do not charge for more than 24 hours straight.
This could damage the unit’s recharging system.
• Avoid rough handling such as bumping or dropping.
• Avoid extreme temperatures. For best results, use
between the temperatures of 39º F and 100º F
(4º C and 38º C).
• Clean only using a slightly damp cloth. Do not use
cleaners with chemical agents.
• Do not expose your Forever Flashlight Rip Cord to
direct sunlight or other heat source for any length
of time.
• Do not expose your Forever Flashlight Rip Cord
to direct extreme cold, dusty or humid areas.
• Clean the lens with glass-cleaning products.
• Do not use petroleum distillates (such as gasoline or
kerosene) or solvents such as acetone to clean
any part of the Forever Flashlight Rip Cord.
** This product uses rechargeable batteries for energy
storage that may need to be replaced after
extended use.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable l interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
