Excalibur P95-2 Zero Clearance Direct Vent Gas Fireplace
26
Door
Flange
OPTIONAL
SCREEN DOOR
GLASS DOOR
INSTALLATION
1) Fit top door bracket over the flange at the
top of the firebox.
2) Secure with 3 screws on the bottom.
FRONT FACADE
INSTALLATION
2) Place the Front Facade into position by
sliding the 2 holes in the bottom brackets
over the pins on the base, one on each side.
Fit the bottom brackets over
the pins on the base.
View from underneath of the
screw and the bracket.
Tab
Tighten both screws to secure Front
Facade to Glass Door.
3) Mount the 2 screws back onto the mounting
plate on the rear of the facade through the
tab on the glass frame and then tighten
screw to secure.
Secure left side with 2 screws and right
side with one screw.
1) Remove the 2 screws from the mounting
plate that are on the back of the facade.
Screw
Remove screws from the
mounting tabs.
4) Slide Bottom Louver into position. On each
side secure the bottom screw first into the
side bracket. Do not overtighten, leave slight-
ly loose to allow the louver to move freely.
Secure
Screw
Bracket
Pin
5) Attach the two control boxes to the bottom
unit base and tighten the 2 screws on the
left side and 1 screw on the right side.
1) Attach door bracket to side using 2 screws
to the left and right side of the unit.
Door Bracket
attaches with
2 screws.
2) Slide the door(s) onto the hinges.
Adjusting the Plunger: Loosen the screw
that holds that plunger bracket so that you
can remove the plunger.
Loosen the
screw holding
the bracket.
Once the plunger has been removed take a
pin and put it in the hole that is in the round
part of the plunger and adjust it accordingly
by turning it to the left or right.
Adjust plunger by
turning it to the left
or right with a pin.
