6
18 Pin Secondary Wire Harness (cont’d)
RED/WHITE WIRE - TRUNK RELEASE / 2ND CHANNEL (-) OUTPUT
This output provides a 250mA negative output when the trunk release/CH2 function is activated
by the controller� The output will remain as long as the controller button(s) is held�
CONNECTION:
Connect this wire to the vehicle’s existing trunk release switch if it is a low current
negative circuit� If the circuit is a high current ground or a positive circuit, the use of a relay is re-
quired�
NOTE: The built-in horn relay circuit can be programmed & utilized for trunk release
if not being used otherwise�
BLACK/RED WIRE - LIGHT RELAY N/O (+/-) INPUT
This circuit provides the constant feed input for the built-in 10 amp domelight relay. Specifically
the normally open pin (pin 87)� This relay can be programmed via installer feature #2 for LOCK,
IGNITION, or ACCESSORY if need be�
CONNECTION:
Connect this wire to constant power or chassis ground as needed for the chosen
function�
GREEN/VIOLET WIRE - LIGHT RELAY COM OUTPUT
This circuit provides the output for the built-in 10 amp domelight relay. Specifically the common
pin (pin 30)� This relay can be programmed via installer feature #2 for LOCK, IGNITION, or AC-
CESSORY if need be�
CONNECTION:
Connect this wire to the vehicle circuit chosen to be driven� By default, connect to
the vehicle’s domelight circuit�
WHITE/RED WIRE - LIGHT RELAY N/C INPUT
This circuit provides the input for the built-in 10 amp domelight relay. Specifically the normally
closed pin (pin 87a) which is typically only used for polarity reversing circuits� This relay can be
programmed via installer feature #2 for LOCK, IGNITION, or ACCESSORY if need be�
CONNECTION:
Connect this wire to constant power or chassis ground as needed for the chosen
function�
VIOLET/BLACK WIRE - HORN RELAY N/O (+/-) INPUT
This circuit provides the constant feed input for the built-in 20 amp horn relay. Specifically the
normally open pin (pin 87)� This relay can be programmed via installer feature #3 for UNLOCK,
TRUNK RELEASE, or PULSE AFTER START if need be�
CONNECTION:
Connect this wire to constant power or chassis ground as needed for the chosen
function�
BLUE/BLACK WIRE - HORN RELAY COM OUTPUT
This circuit provides the output for the built-in 20 amp horn relay. Specifically the common pin
(pin 30)� This relay can be programmed via installer feature #3 for UNLOCK, TRUNK RELEASE,
or PULSE AFTER START if need be�
CONNECTION:
Connect this wire to the vehicle circuit chosen to be driven� By default, connect to
the vehicle’s domelight circuit�
BROWN/BLACK WIRE - HORN RELAY N/C INPUT
This circuit provides the input for the built-in 20 amp horn relay. Specifically the normally
closed pin (pin 87a) which is typically only used for polarity reversing circuits� This relay can be
programmed via installer feature #3 for UNLOCK, TRUNK RELEASE, or PULSE AFTER START if
need be�
CONNECTION:
Connect this wire to constant power or chassis ground as needed for the chosen
function�
