9
Using The Valet Switch (cont’d)
REmOTE START VALET mODE
, disables remote start� Keyless entry and alarm
functions still operate� To enter remote start valet mode, perform the following steps:
STEP 1 -
Disarm the system (by remote or by emergency override)
STEP 2 -
hold the brake pedal then press and hold the valet switch for 2 seconds�
The system will chirp once and the gREEn status light will turn on�
FULL VALET mODE
combines both alarm & remote start valet modes� To acti-
vated full valet mode, follow these steps:
STEP 1 -
Enter remote start valet� you will hear a chirp�
STEP 2 -
Release the brake pedal but continue holding the valet switch� After 2 sec-
onds, you will hear a second chirp�
STEP 3 -
Immediately release the valet switch� The status light will alternate between
RED and gREEn every second�
EXiTinG VALET mODES
- Press and release the valet switch once� The status
light will turn off� This procedure is the same for all forms of valet mode�
SECURECODE
SecureCode allows you to customize the number of valet presses required to
perform an emergency override. SecureCode has 2 stages with the first requiring 1-9
button valet presses and the second requiring 0-9 valet button presses. This gives
you 99 possible combinations� To program a custom SecureCode, please refer to
user feature #1�
To perform an emergency override with SecureCode, use the following steps:
STEP 1 -
With the system armed, enter the vehicle (the alarm will activate)�
STEP 2 -
Turn the ignition switch to the “On” position�
STEP 3 -
Within 5 seconds of step 2, press the valet switch to enter the first digit of
your programmed code�
STEP 4 -
After a few seconds, the siren will stop sounding and chirp once (confirming
stage 1)� The siren will then continue sounding�
STEP 5 -
now, within 5 seconds of step 4, press the valet switch to enter the second
digit of your code� If the code is correct, the alarm will disarm�
If the code is entered incorrectly, turn the ignition key OFF, then back On to try
again�
If 2 failed attempts are made, no further attempts can be made for 2 minutes�
The Status Light
The status lights, located in the window-mount antenna, provide a visual indication
of the system’s status via gREEn (remote start status) and RED (alarm status) lights�
SECURiTY SYSTEm STATUS (RED LiGhT):
OFF:
The alarm is disarmed and not performing any automatic functions�
On COnSTAnT:
The alarm is in valet mode�
FLAShinG SLOw:
The alarm is armed and monitoring all entry points�
FLAShinG FAST:
One of the automatic arming features is in progress�
AUTOmATiC TRAnSmiTTER VERiFiCATiOn (RED LiGhT):
Every time you turn on the ignition key, the status light will flash a number of times
equal to the number of transmitters programmed to the system. This unique security
feature protects you from a potential thief (valet attendant, mechanic, installer, etc�)
from adding their own transmitter without your knowledge and accessing your vehicle
and it’s contents at a later time (the perfect crime!)�
ZOnE ViOLATiOn RECALL:
If the security system is triggered, upon disarming, the RED status lights will
