B. Reverse Osmosis Feed Water Ball Valve
Installation
3. With the Reverse Osmosis Feed Water Ball
Valve closed, open the Reverse Osmosis
sink faucet and the water supply and allow
the water to run for a few minutes to flush
any debris caused by the installation.
Close the Reverse Osmosis faucet and
check the Reverse Osmosis Feed
Water Saddle Valve for leaks.
Once installation of Reverse Osmosis
System is completed open Revere
Osmosis feed saddle valve to allow
flow of water.
Decide on location. Do NOT connect
Reverse Osmosis to a hot water feed line.
Water over 100
º
F may cause permanent
damage to the Reverse Osmosis Membrane.
(Refer to Fig. 3 page 8.)
1. Shut off the water supply and drain the line
from the Reverse Osmosis system.
2. To install the Reverse Osmosis Feed Water
Ball Valve:
Attach the self piercing saddle valve to
pipe and secure and tighten.
Remove nut from the Reverse Osmosis
feed water ball valve.
Slide the nut onto the ¼” reverse
osmosis tubing.
Insert the ferrule and tube insert onto ¼”
tubing
Place the ¼” tubing onto the exposed
threads of the Reverse Osmosis feed self
piercing saddle valve.
Screw the nut onto the Reverse Osmosis
feed water ball valve.
6
REVERSE OSMOSIS SELF PIERCING
¼” FEED WATER SADDLE VALVE
Summary of Contents for EWR 5075
Page 5: ...3 BALL...
