Page | 30
IR Remote Control Setup
The e68 DAC is configured to work with the supplied remote control. You can reprogram the e68 DAC to
work with most infrared remote controls using Sony and NEC IR protocols.
Use the following procedure to change remote control button assignments or to pair the e68 DAC with a
different remote control:
1.
Power on the e68 DAC. Make sure that the unit is not in
playback mode.
2.
Press the
Setup
button.
3.
Press the
Volume Up
button to confirm the remote control
programming mode, or press the
Volume Down
button to
cancel the operation.
4.
Point the remote control to the e68 DAC display. Press and hold
down the remote control buttons for about one second during
each step below to assign functions to them.
5.
Press the remote control button for increasing the volume.
6.
Press the remote control button for decreasing the volume.
7.
Press the remote control button for selecting the next input.
8.
Press the remote control button for previous input.
9.
Press the remote control button for turning the unit on and off.
10.
Press the remote control button for mute.
11.
Press the remote control button for turning the display light on
and off.
12.
Wait until the remote control configuration is saved. Your e68
DAC is now paired for use with the new IR remote control.