Exalt Installation and Management Guide
EX-r Series GigE Digital Microwave Radios
23
201872-003
2015-10-23
Figure 13
EX-r Series GigE
connectors
Connector Overview
The primary user interfaces are shown in Figure 13. Table 2 provides details of the connectors.
Detailed pin structures for each connector are in
.
Table 2 Connectors
Connector
Description
TDM 2&4
Ports for up to two user T1 or E1 circuits to traverse link, port numbers 2 and 4.
TDM 1&3
Ports for up to two user T1 or E1 circuits to traverse link, port numbers 1 and 3.
Sync Out
Connect to Sync In of neighboring radios for network synchronization.
Sync In/RSL
(1) Connection to Sync Out of neighboring radio (optional) external GPS antenna for network
synchronization.
(2) Antenna alignment RSL voltage (during installation)
Ethernet 2
Secondary connector for 10BaseT, 100BaseT, or 1000BaseT for networking appliances or out-of-
band management configurations.
Power/Ethernet
Connected cables traverse to the power injector (Data+Power side), and provide the following
functions:
•
Primary ports for user Ethernet data (10BaseT, 100BaseT, or 1000BaseT) to traverse link
•
DC power from power injector
(Ground)
Threaded (M5) receptacle.
The connectors supplied with the radio have pre-inserted weatherproof inserts. Remove (and
save) these inserts for any connectors that will be cabled. Keep the inserts in place for any
unused connectors.
