
Exalt Installation and Management Guide
EX-r Series GigE Digital Microwave Radios
21
201872-003
2015-10-23
I nstallation
This section presents all tasks required to install the Exalt Digital Microwave Radio.
Mechanical Configuration and Mounting
The EX-r Series GigE radios are environmentally sealed units intended for deployment outdoors. The
device must be deployed within an ambient temperature range as specified, and with non-restrictive
airflow around the chassis. The EX-5r-c GigE can also be mounted in an enclosure or indoors. The
same airflow and temperature conditions apply. All EX-r Series GigE models can be mounted behind a
window if window losses are considered in the link budget calculation.
Provide proper clearance for all cables and connectors attached to the device.
Note that for the EX-5r-c GigE the RF cable connector may require significant clearance for the bend
radius of the coaxial cable assembly. All RF connectors, cables, and adapters must be rated for
operation within the radio’s frequency range. RF connector losses must be accounted for within the
link engineering design and output power settings.
Mounting the System
Use the mounting system supplied with each terminal for wall or pole mounting (Figure 10). The pole
mounting kit can accommodate a pole 2–5"/5–13cm in diameter. Install the mounting system first, and
then affix the radio to the mount. The radio can also be affixed to the mount, and the entire assembly
(including radio) mounted.
Figure 10 Pole-mount example
Figure 11 illustrates the pole/wall mount assembly, showing the azimuth and elevation adjustment
points.
Note:
The power injector and power supply must be placed indoors or in an enclosure.
Note:
There are two RF connectors on the EX-5r-c GigE that facilitate connection to a cross-
polarized antenna for polarization diversity. Seal the secondary connector when using a
single-polarized antenna. Use the N-type cover cap and weather-seal tape included in the
accessory kit to weatherproof this connector.