eXact PipeCut Infinity, Operating Instructions Manual

Page: 13 / 20

Operation English
12
When the pipe is cut off, push the UNLOCK SWITCH
forward until the yellow mark is visible and the locking
is released (FIGURE H 1 / 2).
Raise the motor unit to starting position (FIGURE I / 1).
Release the power switch locking by pushing the power
switch fully in and then releasing it. (FIGURE I / 2).
Ensure that the moving lower blade-guard is lowered
into down position.
When the blade has stopped, loosen the chain by
turning the tightening knobs counterclockwise.
Cut the chain into separate pieces by removing the
attachment pins.
Should there be problems during piercing or cutting;
abnormal sounds or vibrations or you must interrupt
cutting before the pipe is cut, release the motor unit
locking by pushing the UNLOCK SWITCH forward until
the locking is released and lift the motor unit up. Once
the problem is cleared, start cutting again.
Never start the motor when it is locked in sawing
position, or the teeth of the blade are in contact with the
pipe to be sawn.
FIGURE H
FIGURE I