EWT MaxiHC B/W, Installation And Operating Instructions Manual

Page: 5 / 124

Standby
• When the appliance is plugged in there will be an audible beep.
.
First time setup?
YES
On first time start-up the product will start
with the default settings. The temperature will
be set to 22ºC and the heat setting will be set
to intelligent heat mode, see Heat Selection
on the screen below
• When put into standby mode there is a countdown from 10 to 1 before shutting down.
• When disconnected from the power supply (plugged out/power cut/tilt switch) then
reconnected and turned back on product will return to last used settings for Heat Selection, Fan
Selection, Temperature Setting, Sound and Audio. Bluetooth will attempt to re-pair. Runback
Timer and Oscillation will return to OFF.
Note:
Inactive buttons
will not beep when pressed.
Standby mode
Power going to the product but the product
is not turned ON. Once the standby button
has been pressed the product will turn ON
and STANDBY icon will turn OFF.
Press the Standby button to turn the product On.
NO
When subsequently turned on the product
will return to the last used settings for Heat
Selection, Fan Selection, Temperature Setting,
Sound and Audio. Bluetooth will attempt to
re-pair, see Bluetooth. Runback Timer and
Oscillation will return to OFF. The screen below
shows an example where the user previously
set temperature to 25ºC and Heat Selection
to LOW.
Press the Standby button to put the product into Standby.