Chapter 3
Base Unit Hardware Description
3.3.1. LED Panel
3.3.1.1. System
PWR
Power
Green ON = power is present
USR
User
Green ON + OFF, slowly = Unit is OK
RED pattern = special attention required
DI1
Digital input 1
Green ON = Signal on input 1 detected
DI2
Digital input 2
Green ON = Signal on input 2 detected
DO
Digital output
Green ON = Output is in ON state (energized)
BI1
Button BI1 input
Green ON = Reset button is being pressed
- Note -
The Base Unit model specific LEDs are addressed in the specific interfaces of each model. .
3.3.2. Reset Button
The reset button allows to reset the Base Unit partially or completely. For the reset
procedures check §
3.3.3. SD-Card
Currently not supported, the Base Unit operates normally without SD-Card inserted.
3.3.4. Main Connector
The eWON Flexy is powered via its main connector using a male connector (a mating
female connector with screw terminals is delivered with the eWON Flexy Base Unit).
For details see §
3.3.5. Four Slots for Extensions
The slot fillers can be removed to add Extension Cards. A general overview of the available
Extension Cards is available below in this guide.
Page 18 / 40
eWON Flexy - Base Units | IG 014
