Rectifying faults
Vent coolant circuit
54
099-005607-EW501
20.11.2020
Wire feed problems
Wire feed roll holder is worn (wire feed rolls must be firmly seated on their holders and must not have
any play)
Replace wire feed roll holder (092-002960-E0000)
Contact tip blocked
Clean, spray with anti-spatter spray and replace if necessary
Setting the spool brake
Check settings and correct if necessary
Setting pressure units
Check settings and correct if necessary
Worn wire rolls
Check and replace if necessary
Wire feed motor without supply voltage (automatic cutout triggered by overloading)
Reset triggered fuse (rear of the power source) by pressing the key button
Kinked hose packages
Extend and lay out the torch hose package
Wire guide core or spiral is dirty or worn
Clean core or spiral; replace kinked or worn cores
7.4 Vent coolant circuit
Figure 7-1
• Switch off the machine and fill the coolant tank to the maximum level.
• Unlock the quick-connect coupling with a suitable tool (connection open).
To vent the cooling system always use the blue coolant connection, which is located as deep as
possible inside the system (close to the coolant tank)!
Figure 7-2
• Position a suitable collection container for collecting the escaping coolant at the quick-connect coup-
ling and switch on the machine for approx. 5s.
• Lock the quick-connect coupling by pushing back the locking ring.