Design and function
Machine configuration menu
52
099-000188-EW501
22.02.2016
5.13 Machine configuration menu
ENTER (enter the menu)
• Switch off machine at the main switch
• Press and hold the "welding parameters" button and switch the machine on again at the same
time.
NAVIGATION (navigating in the menu)
• Parameters are selected by pressing the "welding parameters" button.
• Set or change the parameters by turning the "welding parameter setting" rotary dial.
EXIT (leave the menu)
• Select the "Elt" menu item.
• Press the "welding parameters" button (settings will be applied, machine changes to the
ready-to-operate status).
5.13.1 Power-saving mode (Standby)
You can activate the power-saving mode by either pressing the push-button for a prolonged time or by
setting a parameter in the machine configuration menu (time-controlled power-saving mode).
When power-saving mode is activated, the machine displays show the horizontal digit in the
centre of the display only.
Pressing any operating element (e.g. tapping the torch trigger) deactivates power-saving mode and the
machine is ready for welding again.
- See 4.3 Machine control
– Operating elements chapter
- See 5.13 Machine configuration menu chapter
ENTER
EXIT
NAVIGATION
+
l
0
Figure 5-25
Display
Setting/selection
Lock JOB menu
Protect welding parameters from unauthorised access.
Settings
Settings for machine functions and parameter displays.
Time-based power-saving mode
------- inactivated
5 min.
–60 min. = Time to activation of power-saving mode in case of inactivity.
Exit the menu
Exit
