Design and function
MIG/MAG welding
68
099-005183-EW501
17.12.2010
Display Setting/selection
Ramp time for wire inching
0 = normal inching (10s ramp time)
1 = fast inching (3s ramp time) (Ex works)
Block program "0"
0 = P0 enabled (Ex works)
1 = P0 blocked
POWERCONTROL torch display mode
0 = normal display (factory setting)
program number/JOB or
welding performance/welding voltage correction is displayed
1 = alternating display
display alternates between program number and welding type
Program limitation
Programs 1 to max. 15
Ex works: 15
Special cycle in the special latched and non-latched operating modes
0 = normal (previous) non-latched/latched (Ex works)
1 = WF3 cycle for non-latched/latched
Correction operation, threshold value setting
0 = correction operation switched off (Ex works)
1 = correction operation on
"Main program (PA)" flashing
Program changeover with standard torch
0 = no program changeover (Ex works)
1 = special latched
2 = specific latched special (n cycle active)
Lat. and sp. lat. tapping start
0 = no latched tapping start (Ex works)
1 = latched tapping start possible
One or two-wire feed operation
0 = single operation (Ex works)
1 = dual operation, this unit is the "master"
2 = dual operation, this unit is the "slave"
Special latched tapping time
0 = tapping function switched off
1 = 300ms (Ex works)
2 = 600ms
JOB list changeover
0 = task-oriented JOB list
1 = actual JOB list (Ex works)
2 = actual JOB list, JOB changeover activated via accessories
Lower limit remote JOB changeover
Lowest JOB that can be selected using PowerControl 2 torches.
Lower limit: 129 (Ex works)
Upper limit remote JOB changeover
JOB range of the POWERCONTROL2 torch
Upper limit: 169 (Ex works)
HOLD function
0 = HOLD values are not displayed
1 = HOLD values are displayed (Ex works)
