Maintenance, care and disposal
Maintenance work, intervals
34
099-500050-EW501
04.08.2016
6
Maintenance, care and disposal
CAUTION
Electrical current!
The following work must always be carried out with the power source switched off.
Disconnect the welding torch from the connected device, before maintenance.
6.1
Maintenance work, intervals
6.1.1
Daily maintenance tasks
• Purge the wire guide from the direction of the Euro torch connector with oil- and condensate-free
compressed air or shielding gas.
• Purge the wire guide from the direction of the Euro torch connector with oil- and condensate-free
compressed air or shielding gas.
• Check that all connections and wearing parts are hand-tight and tighten if necessary.
• Remove any spatter.
6.1.2
Monthly maintenance tasks
• Check and clean the welding torch. Deposits in the torch can cause short circuits and have a negative
impact on the welding result, ultimately causing damage to the torch.
• Check torch, hose package and power connections for exterior damage and replace or have repaired
by specialist staff as necessary!
6.2 Maintenance
work
Electric current!
Repairs may only be carried out by authorised specialist staff!
• Do not remove the torch from the hose package!
• Never clamp the torch body in a vice or similar, as this can cause the torch to be irreparably
destroyed!
• If damage occurs to the torch or to the hose package which cannot be corrected as part of the
maintenance work, the entire torch must be returned to the manufacturer
