Design and function
Assembly/disassembly
099-008268-EW501
21.02.2022
15
5
Design and function
WARNING
Risk of injury from electrical voltage!
Contact with live parts, e.g. power connections, can be fatal!
• Observe the safety information on the first pages of the operating instructions!
• Commissioning must be carried out by persons who are specifically trained in handling
power sources!
• Connect connection or power cables while the machine is switched off!
Read and observe the documentation to all system and accessory components!
5.1 Assembly/disassembly
CAUTION
Improperly fastened machines!
Devices, device combinations and accessories that are not properly fastened to trans-
port systems may tip over during transport and cause injury.
• Use the systems only for transporting the machines specified in .
• Secure the machines in the middle or at the specified attachment points on the machine
carrier.
• Use only the original parts supplied to fasten the machines.
• Check the attachment points before each transport and at regular intervals.
Risk of accidents due to supply lines!
During transport, attached supply lines (mains leads, control cables, etc.) can cause
risks, e.g. by causing connected machines to tip over and injure persons!
• Disconnect all supply lines before transport!
5.2 Preparations
Figure 5-1
Item Symbol Description
0
1
Threaded grooved pin
M5 x 16 mm
• Remove threaded grooved pins, M5 x 16
The screws will be needed again for mounting.
