1.2. Electrical Installation
The electrical installation of the EyeCheck Vision-System must be carried out by
a qualified electrician.
When installing the EyeCheck Vision-System, disconnect all electrical
components from the power supply.
When the unit is being used in a network, ensure that the network address (IP
address) of the EyeCheck Vision-System set by the manufacturer is free and is
not in use for any other unit connected to the system.
If necessary, re-set the IP address of the EyeCheck Vision-System. When the
EyeCheck Vision-System is in use, the protective caps supplied must be pushed
onto the M12 sockets (data and LAN) which are not in use. Failure to do this may
cause malfunction.
1.2.1. Connection Possibilities
For stand-alone operations (independent of PC / PLC) only connection 24V DC is required after start-
up.
For electrical installation, connect wires as follows:
LED display
Focussing screw
24 V DC
M12 connection socket
Data (RS232)
M12 connection socket
LAN
M12 connection socket
EyeCheck
24 V DC (I/O)
DATA (RS422)
LAN (Ethernet)
24 V DC
PLC
PC
Fig. 3
Fig. 4