12
Pressure regulation
With pressure regulator (7) working pressure can be adjusted, as measured by gauge (6). Set
pressure could be taken from the quick coupling (5). The pressure in the tank could be measured
at any time with pressure gauge (12) and could be taken from the quick coupling (16).
Pressure switch adjusting
The pressure switch is set by factory, do not adjust it.
Starting pressure : 6 bar
Stop pressure 8 bar
Condensation discharge
Water condensation should drained weekly by opening the drain valve (11) located in the bottom
of rezervorului .WARNING! Condensation liquid may contain traces of oil.
Cleaning and maintenance
WARNING! Before any intervention on the machine, disconnect the power supply
from the mains and wait until the compressor has cooled completely! Risk of
burns!
WARNING! Before performing any cleaning or maintenance operation
completetly drain the air tank
General cleaning
Regularly clean the machine housing with a soft cloth, preferably after each use.If the dirt
does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
Air filter cleaning (1)
The air filter prevents dust and dirt intake. It is necessary to clen the filter afterno more than 100
hours of operation. A clogged air filter greatly reduces compressor power. Remove the filter and
loosen the butterfly screw .remove the filter from the two halves of the plastic housing, clean it and
blow it with compressed air at low pressure (approx. 3 bar). Place the filter back then.
Oil replacement
Recommended Oil SAE 15W / 40 or similar.
The oil must be changed after filling the first 100 hours of operation. After that the oil must be
replaced every 500 hours of operation
To replace the oil, stop the engine and pull the plug. Once you have completely evacuated the air
from the tank, you can unscrew the oil drain cap (15) from the compression chamber. To avoid an
uncontrolled leakage of oil,place a gutter underneath, and collect the oil in a container. If the oil
does not drain completely, we recommend to tilt a little thw compressor.
After completely draining the oil tighten the oil drain cap (15) back in place. Fill with new oil
through the hole (14) until the level needed. Then tightening the oil cap.
Used oil and condensate must be disposed of in compliance with protection of environment and
current legislation.
Maintenance
Our machines have been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper machine care and regular
cleaning.
