Kit contents
1 x Reflector Bracket
2 x M5 Nyloc Nuts/Washers
1 x Reflector
2 x M4 x 8 C/Sunk Screws
1 x R/H Bracket
3 x Female Connectors
1 x L/H Bracket (4 small holes for cable ties)
3 x Male Connectors
1 x Rear Light Assembly (including fittings)
4 x M6 x 16 Black b/h screw
1 x Back Plate
4 x M6 Black Washers
2 x Number Plate Screws & Nuts
6 x Cable Ties
Fitting Instructions
1. Remove the pillion seat.
2. Remove L/H and R/H side panels (screws and pull out).
3. Remove front seat (screws).
4. Remove rear body panel (7 screws). Flex carefully and lift to one side.
5. Loosen screws in R/H exhaust cover. Remove L/H exhaust cover (2 screws on
top) VERY CAREFULLY EASE FORWARD AND OFF -Very small tags along
rear seam.
6. Remove small panel over rear light by pushing in centres of plastic plugs and lift
away.
7. Remove L/H and R/H indicators (3 screws) and unplug connectors.
8. Remove indicator mounting plate (2 screws).
9. Disconnect rear lights, remove rear light/number plate assembly (2 screws each
side).
10. Fit R/H bracket to exhaust and tighten using 2 screws/washers supplied.
11. Loop 2 cable ties to L/H bracket from outer side and loosely attach
bracket to exhaust.
12. Assemble indicators to back plate, insert 2 cable ties loosely from the
inside of the bracket.
13. Offer up back plate to mounting brackets, feed R/H indicator wire
through cable ties across and out through L/H bracket. Support bracket.
14. Offer up rear light, pass wires through rear plate, through L/H cable tie
and out through L/H bracket. Tighten cable ties on back plate and fix
rear light using two nuts and washers supplied.
15. Pass the wires up through the big hole in L/H bracket, through cable
ties neatly and tighten cable ties, at this point tighten L/H bracket
fixing screws.
16. Fix back plate to mounting brackets using 2 c/sunk screws supplied.
17. Re: connect indicators.
18. Connect rear light wires using connectors supplied, as follows:
REAR LIGHT ASSEMBLY BIKE
RED----------------Brake light----------------Blue/Red
BLACK------------Earth------------------------Black/yellow
YELLOW---------Rear Light------------------Red
(ignore stock connector for old number plate light as it is now illuminated
by rear light)
Check lights and indicators work correctly and wire routing and all fixings
are tight.
19. Reassemble, reversing steps 1-5. Fit number plate and apply reflector
to rear of machine.
Please visit:
www.evotech-performance.com
to view our full product range
