DEPOLOX® 400 M
6. Operation
53
EN
6.2
“Measurement” menu
This menu shows the current measured value
and the sensor signal. All settings relating to
measurements, such as range, limit values,
controller settings and calibration must be
made via this menu.
1 Call up the Home menu.
2 Tap the desired measurement (e.g. Cl
2
free).
3 Tape
symbol.
Depending on the measurement selected, dif-
ferent setting parameters are displayed.
Swipe upward on the touchscreen to access
further setting parameters which are further
down the list and not currently visible on the
screen.
The settings menus are subdivided into vari-
ous areas such as Measurement, Controller
and Dosing. To change values, press the corre-
sponding parameter.
Message/error active
Tap the symbol to open the mes-
sage window.
•
Yellow symbol = alarm that
cannot be acknowledged is
active
•
Red symbol = alarm that can
be acknowledged is active or
error message is active
•
Orange symbol = mainte-
nance or calibration interval
expired
Data logger symbol USB memory
stick
Menu Alarms
Digital input active
Sample water Stop
Alarm active (1 to 8)
Calibration menu
Settings menu
Acknowledge button
Selection disabled
Selection enabled
Controller Stop
Controller manual mode
Controller constant
Controller automatic mode
System menu
Menu/Measurements display
Confirmation prompt
Information
Note
Abort/Close
Symbols
Meaning
DI
ACK
NOTICE
Depending on the user administration confi-
guration and the currently registered users,
the changes that can be made are limited. In
order to change parameters, login on the
corresponding user level is required (chap-
ter 6.3.8).
