Evolveo StrongVision R1, User Manual

Page: 6 / 17

NUMBER

number of a shot
PASSWORD

camera PIN code protection
FIRST START
Set the switch to "TEST" position and adjust the camera parameters in the well-arranged
camera display according to your needs.
Record browsing mode
Set the switch to "TEST" position, press the "right arrow" button on the remote control.
Photo browsing: press the "up" or "down arrow" button
Video viewing: press the "left arrow" button to start or paused a video
Press "OK" to exit the browsing mode
Troubleshooting
Problem Solution
Photos are blurry,
too grainy, etc. The cause of this is probably a bad wind conditions, snow, rain, fog,
etc.
Do you still need advice after reading this manual?
First read “Frequently Asked Questions” at
www.evolveo.com/en/strongvision-r1 or
contact the EVOLVEO technical support.
TECHNICAL SUPPORT
www.evolveo.com/en/support
The warranty DOES NOT APPLY to:

Using the device for other purposes than it was designed to.

Installation of another firmware instead of the default one or the one that can be
downloaded manually or automatically from the device menu.

Electrical or mechanical damage caused by improper use.

Damage caused by natural elements such as fire, water, static electricity, power
surges etcetera.

Damage caused by an unauthorized repair.

Damage to the guarantee seal or an unreadable serial number on the device.