Evolveo FreeTalk 2W, Manual, Page: 5 / 7

4.12 Dual Channel Monitor(DCM)
Enables you to scan the current channel and another channel alternately.
To set another channel and start Dual Channel Monitor:
1. Press the MENU button 8 times until the “DCM” icon appears. The “OF” icon will flash.
2. Press the UP ▲ /Down ▼ button to select the channel “ON” then press MENU.
3. The Channel NO. will flash, press the UP ▲ /Down ▼ button to select another channel you
would like to use.
4. Press the PTT button to confirm your selection and return to the stand-by mode. The two
channel NO. will flash and alternate display.
4.13 Scanning for an active radio channel
Press button: The “SCAN” function indicator will appear on the display and the channel
will scan continuously one by one. Once an active channel is found, the scanning will stop
and you can listen to the transmission.
When the transmission is on the found channel stop, the scanning will resume
automatically.
Note: If you press PTT button while listening to a found channel, the device will go back to
stand-by mode on the found channel.
4.14 Monitor
Press and hold the MON/UP ▲ button about 3 seconds to active monitor.
Release the MON/UP ▲ button return to stand by mode.
4.15 Sending a call tone
Press the PTT button one time quickly, the call tone will be transmitted on the setting
channel.
4.16 Backlit display
Press any button except for the Lamp and PTT button to activate the back light of the LCD
display. The back light will light on about 5 seconds.
4.16 Earpiece connection
The device can be used with earpiece (If there is earpiece packed together with the device).
The connector is located on the top of the device.
Insert the earpiece plug into the connector (2.5mm jack).
There is a small “PTT” button on the earpiece that has the same function as the PTT button
on the device.
When you use the PTT button from the earpiece, you must also use the microphone from
the earpiece to talk.
Note: Do not connect other earpieces, it may damage your device.
4.17 Battery saving function
When the device has not been used for 6 seconds, the economy mode is automatically
activated. This does not affect the reception of transmission and the stand by mode is
automatically re-activated as soon as a signal is detected.