www.evolutionbuild.com
11
7. Reinstall the outer drive flange and the
arbor socket headed screw.
8. Engage the arbor lock and tighten the arbor
socket headed screw securely using the
Allen key.
Note:
The socket headed arbor screw has a
RH thread.
9. Check that the arbor lock is fully released
by manually rotating the blade.
10. Check the operation of the safety guard.
Parallel Edge Guide
A parallel guide (for help when rip cutting)
can be fitted to the sole plate of the machine
The guides arm should be inserted into the
rectangular slots found at the front of the sole
plate, and slid under the locking thumb screw.
(Fig. 4)
Note:
The edge guide can be fitted to either
side of the sole plate and should only be fitted
and adjusted with the machine disconnected
from the power supply.
Adjust the edge guide so that it is at the
required distance from the blade and tighten
the two thumb screws. Check that the edge
guide is parallel to the saw blade.
Adjustment of the Cutting Depth
Loosen the Depth Adjustment Locking
Screw to adjust the sole plate to give the
required cutting depth. A scale can be found
on the depth bracket and an index mark is
incorporated into the machines upper guard
to aid setting. In most cases depth should be
set at maximum unless there are obstructions
below the work surface. Tighten the Depth
Adjustment Locking Screw securely to lock in
the required position.
(Fig. 5)
FIG 4
FIG 5