25
www.evolutionpowertools.com
Note:
Check that the Rip Fence is locked in position and is
parallel to the saw blade. Check that the riving knife is properly
aligned with the saw blade.
When ripping small section material a Push Stick should be
used to feed/guide the final 300mm of the material past the
blade. A Push Stick should always be used when making cuts of
less than 300mm.
Note:
A Push Stick
(Fig. 25)
is provided with the R210MTS and
has a dedicated storage position to the front of the machine.
We recommend that when not in use the Push Stick is stored on
the machine.
When ripping long boards or large panels always use a remote
work support or enlist competent trained help.
Feed the workpiece through the saw keeping it indexed against
the Rip Fence. Use smooth, steady pressure and employ a Push
Stick when necessary.
Hands should never be in line with the blade.
MAINTENANCE AND ADJUSTMENTS
WARNING:
Ensure that the machine is disconnected from
the mains supply before any maintenance tasks or adjustments
are attempted.
Cleaning
After each use the machine should be cleaned. Remove all
sawdust etc from the visible parts of the machine with a
vacuum cleaner. A vacuum cleaner can also be connected to
the machine dust extraction port at the rear of the machine.
This should remove debris from the inside of the machine.
Never use solvents to clean plastic parts, as solvents can
damage them. Clean only with a soft slightly damp cloth.
Fig. 25