15
www.evolutionpowertools.com
GETTING STARTED
WARNING:
ALWAYS DISCONNECT THE SAW FROM THE POWER
SOURCE BEFORE MAKING ANY ADJUSTMENTS.
Refer to the “Service Parts Diagram”. Install a blade as detailed in
the “Installing or Removing the Blade” section.
Note:
We recommend that the operator reads the ‘Important
Information’ sticker applied to the table of the R210MTS.
Practicing and becoming familiar with the procedures outlined
on this sticker will make subsequent adjustments/assembly or
configuring fairly straightforward.
PERMANENTLY MOUNTING THE R210MTS TABLE/
MITRE SAW (Fig. 1)
WARNING:
To reduce the risk of injury from unexpected saw
movement, place the saw in the desired location either on a
workbench or other recommended leg set. The base of the saw
has four holes to mount the mitre saw. If the saw is to be used in
one location, permanently fasten it to the workbench or leg set
using appropriate bolts with lock washers and nuts.
Note:
When permanently mounting the R210MTS we
recommend that the four (4) rubber feet located underneath each
of the mounting holes are removed and stored safely for possible
future use.
1. Tighten the mitre and bevel locks.
2. Position the saw so other people cannot stand behind it.
Thrown debris could injure people in its path.
3. Place the saw on a firm, level surface where there is plenty of
room for handling and properly supporting the workpiece.
4. Support the saw so that the table is level and the saw does
not rock.
5. Bolt or clamp the saw to its support.
FOR PORTABLE USE (Fig. 2)
Note:
The R210MTS is designed to be a highly
portable machine.
For portable use the R210MTS must be fitted with
the two (2) rear Stabilising Arms.
Fig. 1
1) Hex headed bolt
2) Spring washer
3) Flat washer
4) Mitre saw base
5) Workbench
6) Flat washer
7) Spring washer
8) Hex nut
9) Lock nut
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Fig. 2