9. WHEEL
ASSIGN
Use the WHEEL to transmit MIDI CONTROL CHANGE messages. You can select and assign 119 types of MIDI
functions (1-31, 33-95, 102-121, 128-132)
Number
1 –127
128
129
130
131
132
Functions
Standard MIDI controllers
Pitch Bend Sensitivity
Fine Tune
Coarse Tune
Channel Pressure
Velocity
•
Press the WHEEL ASSIGN switches (MEMORY & PROGRAM) together and the LED starts to flash
showing the number of the present MIDI controller.
•
Use numeric keys 0-9 to select a new MIDI controller. You can also use the +/- switches to increase or
decrease the value of the number.
Note:
* If you do nothing for 5 seconds, the LED will return to show the current PROGRAM CHANGE number.
* If the number you press is not in the range of defined numbers, the previous number will be retained.
* When you assign 120 or 121 as the MIDI controller for the WHEEL, you should move the MODULATION
Wheel to the mid-value then return it to the minimum value to send a relative MIDI message.
* See Appendix B for a full list of controller numbers.
10. TRANSPOSE
This function allows you to shift the pitch of the unit in semitones. You can transpose the pitch by 24 half steps (12
up, 12 down).
•
Press the TRANSPOSE switch. The LED shows the current TRANSPOSE value.
•
Press the “+” or “-” switch to change the TRANSPOSE value. Each time you press + or -, the keyboard is
transposed an additional half step.
* Pressing the + and - switches simultaneously resets the pitch to the default value.
Note: Turning the power off always resets the shifted pitch to the default value.
11.
OCTAVE CHANGE
This function allows you to shift the pitch up to three octaves higher or two lower.
•
Press the OCTAVE UP or DOWN to change the octave range. The LED shows the new OCTAVE value.
* Press OCTAVE UP and DOWN switches simultaneously to reset the pitch to the default value.
Note: if the UP or DOWN switch is not pressed for 5 seconds, the LED will return to show the PROGRAM CHANGE
number.
12.
Sending BANK MSB and LSB message
You can send any value of MSB or LSB from 0-127.
•
Press the BANK LSB switch. The LED starts to flash showing the current value of the LSB. Press the
numeric keys to change the LSB value. You can also use the “+” or “-” switches to change the value.
•
Press the BANK MSB switch. The LED starts to flash showing the current value of the MSB. Press numeric
keys to change the MSB value. You can also use the “+” or “-” switches to change the value.
Note:
* if you don’t do anything for 5 seconds the LED stops flashing and shows the current PROGRAM CHANGE
number.
* if the number you input is over 127, it will return to the previous LSB or MSB value.
