• Projected Laser Beam is not parallel with the indentations
=
Follow section A.
• Beam is parallel with but not aligned to the indentations
=
Proceed to B.
Section A.
• Loosen the clamping screw.
(Fig. 8)
• Carefully and gently rotate the laser module, until the line is
parallel with the marks in the cardboard.
• Re-tighten the clamping screw.
• Recheck the alignment.
Section B.
Laser beam parallel with the indentations, but not going
through them:
• Slacken the two hex screws.
(Fig. 9)
• The laser mounting block can now be moved sideways to align
the laser beam with the indentations made in the cardboard.
• When the laser beam is in the correct place, re-tighten the
two screws.
• Repeat procedure
‘A’
to check alignment.
Note:
The above adjustments & alignments should be checked
on a regular basis to ensure laser accuracy.
Note:
The following
WARNING
labels may be found on
this machine:
LASER RADIATION
DO NOT STARE INTO THE BEAM
CLASS 2 LASER PRODUCT
CLASS 2 LASER PRODUCT
LASER RADIATION
AVOID DIRECT EYE CONTACT
Fig. 8
Fig. 9
16
www.evolutionpowertools.com
