Evolution 33cc, User Manual

Page: 5 / 72

EN
5
Throttle
Arm
Rail-mount Installation
1. Remove the 4 screws which attach the
rear-mount.
2. Remove the rear-mount and replace the 4
screws with the shorter M3 screws included
with this engine.
3. Secure the engine mount on the airplane
firewall. Tighten the engine mount screws
in the firewall.
4. Install the engine on the engine mount
according to the airplane manufacturer’s
instructions.
Rear-mount Installation
1. Secure the engine to the airplane firewall
using either M5 or 10-32 bolts. Use spacers
or standoffs as needed to set the correct
firewall-propeller distance according to the
airplane manufacturer’s instructions.
WARNING: Tighten all engine
mounting screws before each flight. If
you do not tighten the engine
mounting screws, the screws may
vibrate loose and cause the engine to
separate from the fuselage.
Included Content
ENGINE
• Muffler (EVOG33601)
• Muffler Screws & Gasket (EVOG33100A)
• Spark Plug (EVOG33350)
• Evolution/Spektrum
™
Telemetry RPM
Adapter Cable (EVOA107)
• Large Gas-FKM Fuel Tubing (EVOA109)
• Large In-line Fuel Filter (EVOA111)
• Large In-tank Felt Filter/Clunk (EVOA112)
OPTIONAL ITEMS
• Tachometer (HAN156)
• Propeller 17 x 8 (APC17080) for break-in;
18 x 8 (APC18080) for normal flight
• Optical Electronic Ignition Kill Switch
(EVOA100)
• Evolution Synthetic 2-Cycle Oil, (EVOX1001Q)
• Ultra Fuel Pump (HAN155)
Muffler
Spark Plug
Fuel Nipple
High-Speed
Needle
Choke Arm
Low-Speed
Needle
Installing the Engine