-
To dehumidify connect a water hose to the water tap point (number 6). This hose leads into a
collection tray. Please note that the hose must not go up.
-
To cool you to connect a drain hose.
Use
Cooling mode:
-
Press the "Mode" button until the "Cool" icon appears.
-
Press on the
button to select the desired room temperature. (16ºC-31ºC) -
Press
the "Fan Speed" button to select wind speed.
Dehumidification:
-
Press the "Mode" button until the "Dehumidification indicator" flashes
-
automatically set the selected temperature in the actual room temperature 2 ° C min.
(16ºC31ºC)
-
automatically adjust the fan motor in a LOW wind speed.
Fan Mode:
-
Press the "Mode" button until the "Fan" icon appears.
-
Press the "Fan Speed" button to select wind speed.
Operation of the timer:
ON timer setting:
-
When the air conditioner is OFF, press the "Timer" button and select a desired ON time
through the buttons for the temperature and time setting.
-
"Preset ON Time" is displayed on the control panel.
-
The ON time can be adjusted at any time between 0-24 hours
OFF Timer setting
-
When the air conditioner ON, press "Timer" button and select a desired OFF time using the
buttons for the temperature and time settings.
-
"Preset OFF Time" appears on the control panel.
-
The OFF time can be adjusted at any time between 0-24 hours
Water drainage
-
If you plan not to use this unit for a long time, remove the rubber plug from the drain hole at
the bottom of the unit and connect a drain hose to the lower fixing clip. All water will be
discharged into the water tank.
-
When the water pump is damaged, the constant drainage can be used, and the water pump is
not activated in these circumstances. The device works just fine.
or