EVOC MEC-5031-M Series, Manual

Page: 162 / 205

BIOS Setup
· 56 · MEC-5031-M SERIES
Supervisor Password has been set.

e used to display password status of supervisor and
en there is no password, Cleared will be displayed; If there is

ptions are used to set passwords for supervisor and common user.
er into setup interface.


assword length.

boot. When this option is Enabled, the user password
boot-up. When it is Disabled, the user password
 rity Status
urity information status. If no HDD is detected, “No
HDD Password
User Password option will be displayed, which are used to
et up HDD password function.
Supervisor/User Password is ：
These two options ar
common user. Wh
password, “Set” will be displayed.
Set Supervisor/User Password
These two o
Press < Enter > to ent
Supervisor/User Hint String
These two options are used to set prompt information for supervisor and
common user respectively. They can be directly entered.
Min. Password length
To set minimum p
Authenticate User on Boot
To authenticate user on
needs to be entered for each
needs to be entered during Setup, and this option needs to be set as Supervisor
Password.
 HDD Password Select
Used to select HDD password authority. There are User Only/User+Master
options. These options are displayed only when a hard disk is connected.
HDD Secu
Used to display HDD sec
HDD” will be displayed. If HDD is detected, corresponding
State and Set HDD
check HDD password state, and s
 Boot