Announcement
The information in this manual represents no promise or guarantee by EVOC. EVOC
reserves the right to make changes to the manual, without prior notice to customer.
EVOC will not be held liable for any direct, indirect, intended or unintended losses
and/or hidden dangers due to installation or improper operation.
EVOC
is a registered trademark of EVOC Intelligent Technology Co., Ltd. All
trademarks, registered trademarks, and trade names used in this User’s Guide are the
property of their respective owners.
EVOC Intelligent Technology Co., Ltd. ©2008, Copyright Reserved. No part of this
manual may be reproduced in any form or by any means, electronic or mechanical,
without permission in writing from EVOC.
Safety Instructions
1.
Please read the user's manual carefully before using the product.
2.
Before inserting, removing or reconfiguring motherboard or expansion card,
first disconnect the computer and peripherals from their power sources;
3.
Before removing boards or computer, first turn off all power resources and
disconnect the power cord from power source;
4.
For whole set, when inserting or removing boards, first disconnect the computer
and peripherals from their power sources;
5.
Before you connect or unplug any signal cable, make sure all power cords are
unplugged in advance;
6.
To avoid power on/off computer frequently, wait at least 30 seconds after turning
off the computer before returning on the computer.
7.
Static electricity can harm system boards. Perform service at an ESD workstation
and follow proper ESD procedure to reduce the risk of damage to components;
8.
If there's no ESD workstation, You can take the following steps to prevent
damage from electrostatic discharge (ESD):
a)
Wear a grounded wrist strap against your skin to eliminate static on your
body;
b)
Always touch the metal chassis or frame before you touch any
components in the chassis;
c)
Keep part of your body in contact with the metal chassis to dissipate the
static charge while handling components;
d)
Avoid all unnecessary movement;
e)
Handle components and boards with care. Don’t touch the components or
contacts on a board. Hold a board by its edges or by its metal mounting
bracket;
f)
Place the components on a grounded, staticfree surface. Use a conductive
foam pad if available but not the component wrapper.
g)
Do not let the components slide on the operating platform.
9.
Use cross head screwdriver to operate. A magnetic screwdriver is recommended
(magnet to collect screws). Do not leave any tools or screws inside the chassis;
10. Assure abundant cooling and streamline ventilation.
Summary of Contents for MEC--5004
