EVOC EPE-1815, User Manual

Page: 74 / 123

Installation Instructions
- 8 - EPE-1815
2.4 Jumper Setting
1. JCC1: Clear/Keep CMOS Setting (pitch: 2.0mm)
CMOS is powered by the button battery on board. Clearing CMOS will restore
original settings (factory default). The steps are listed as follows: (1) Turn off the
computer and unplug the power cable; (2) Instantly short circuit JCC1; (3) Turn on
the computer; (4) Follow the prompt on screen to enter BIOS setup when booting the
computer, load optimized defaults; (5) Save and exit. Please set as follows:
Setup Function
1-2 Open Normal (Default)
JCC1
1-2 Short
Clear the contents of CMOS and all BIOS
settings will restore to factory default values.
2. JM1: Clear/Keep ME Register Content (pitch: 2.0mm)
Setup Function
1-2 Open Normal (Default)
JM1
1-2 Short
Clear the content of ME RTC Register will
restore to factory default values.
Note: This jumper is only set up for Q67 series motherboards.
3. JP1: AT/ATX Power-on Mode Selection (pitch: 2.0mm)
Setup Function
1-2 Short AT power-on mode
JP1
2-3 Short ATX power-on mode (Default)