Chapter 2 Installation
EPE1814V2NAR
17
the rear of the CPU card;
Ø
Connect the front side of cooling fin (see figure
⑤
) with the bracketand fix
them; pay attention that the surface between the cooling fin and the CPU crystal
wafer shall be well contacted;
Ø
Fix the cooling fin with two screws on the cross (do not tighten them) and then
the other two screws; then tighten the four screws;
Ø
Lastly, connect the fan power cable to the fan socket on the CPU card.
Note!
1)
It is recommended to use cooling fan authenticated by Intel; before installing the
fan, smear the heat sink compound on the surface between CPU and the fan
cooling fin to improve the heat dissipation performance; always check whether
the fan is operating normally to ensure the heat dissipation within the chassis.
When holding a board, please hold the edge instead of the cooling fin.
2)
When assembling the computer, please fix the attached cooling fin bracket to the
chassis, so as to reinforce and guarantee the stability of the system. The
installation figure is shown as follows:
