24
Phillips Screw (30)
Nyloc Hex Nuts go to
backside
Leg Supports To Leg Frame
n
Some parts may contain sharp edges. Wear
protective gloves as necessary.
Propane (LP) models have two leg supports (left-side and
front) that are installed using phillips screws and nyloc hex
nuts. The third leg support (right-side) is a removable with
keyway cutouts that install over pre-installed fasteners (see
Removable Leg Support below).
1.
Position leg support to inside of leg with removable
installation label on leg support facing outward. Be
sure angle at each end of leg support matches inside
angle of leg.
2.
Visually align screw holes and place phillips screw (30)
into first mounting hole with nyloc hex nut securing leg
support from behind.
3.
Tighten phillips screw to nyloc hex nut and ensure leg
support is engaged and leg support is secured against
inside of leg.
4.
Repeat for all mounting holes of each leg support.
Removable Leg Support
Propane (LP) Models Only
1.
There are two leg supports installed to the leg frame
using 8 phillips screws and nyloc hex nuts. The third
leg support, located on the right-side of the grill,
is provided with keyway cutouts which allow easy
removal for exchanging the LP tank.
2.
The fasteners necessary to engage the removable leg
support are pre-installed at the factory and require no
adjustment. These fasteners are tensioned with a spring
that secures the leg support to the right-front and rear
leg.
3.
Position removable leg support on inside of leg with
the polished factory finish facing outward. Be sure
angle at each end of leg support matches inside angle
of leg.
4.
Visually align keyway holes and leg support over
fasteners.
5.
Pull inward at each end of the leg support, and then
push downward to engage the keyway fasteners.
6.
To remove the leg support, reverse the installation
process.
Fig. 1.14
Fig. 1.15
