9
6. How to light your grill
Ignitor lighting your grill
Notice: For your grill ignitor to function please check the
battery is installed. Do not attempt to use the ignitor to light
the grill burners without first properly installing a functional
battery. Your grill is equipped with an electronic ignitor that
requires one AA battery. To install battery, first remove cap
containing the red or black rubber button located under
the left side of the front control panel by pressing up then
twisting. Insert one battery into the ignitor with the positive-
side (+) of the battery facing upward. Replace the cap,
making sure the button locks into the ignitor.
n
IMPORTANT: Before checking ignitor, turn gas off at
tank and place both control knobs in Off position.
Check to make sure the ignitor is functioning by
pressing ignitor button and hold for 2-3 seconds. A
“Clicking” should be heard, and a spark should be
visible between each collector box and electrode.
Be sure to check both collector boxes and both
electrodes. Be certain that your battery is clean and
operating with a sufficient charge.
1.
Be sure cook surface is properly installed and gas
control knobs are in the Off position.
2.
Turn gas on at tank.
3.
Push in and turn either knob on the control panel to the
Lite position.
4.
Press and hold ignitor button (2 or 3 seconds) to light
grill. Ignitor button is located under the left front corner
of the control panel. Be sure burner lights and stays lit.
5.
After burner lights, adjust knob between High or Low
setting. Repeat for opposite burner.
6.
Warning: If burner(s) do not light, turn both control
knobs to the Off position. After waiting 4 minutes, start
again.
7.
In wind, or if the ignitor does not work, use match.
Match lighting your grill
1.
Be sure gas control knobs are in the Off position.
2.
Be sure grill cook surface is properly installed over
burner skirt.
3.
Turn gas on at tank.
4.
Place long-stem match into flame viewing portal (
Fig.
1.3
).
5.
Push in and turn either knob on the control panel to the
Lite position. Be sure burner lights and stays lit.
6.
After burner lights, adjust knob to High or Low settings.
Push in and turn other knob in order to light opposite
burner.
7.
Warning: If burner(s) do not light, turn both control
knobs to the Off position.
8.
After waiting 4 minutes, start again.
Fig. 1.3
Cook Surface Raised
For Illustration Purposes Only
Insert Match Here
