4
Recommended Tools
:
o
Standard sockets
o
Wrench set
Safety Steps for installation
o
For installing EVO MFG products always use
wheel chokes to block rear tires from rolling.
o
Always make sure you have everything
necessary ready before install.
o
If you have to, carefully lift front of vehicle
by front frame rails extending suspension
until tires leave the ground, place frame on
approved jack stands for vehicle. Verify all
lines/wires are not over extended.
o
Remove tires if needed for easier install.
o
Make sure to wear safety equipment (eye
protection, hand protection, foot protection
etc.) at all times during installation.
o
Make sure all safety precautions have been
taken.
o
Always check and replace any part of vehicle
that is warn or broken before starting install.
o
Do not mix anything EVO with weaker
alternatives.
o
It is generally a good idea to apply liquid
threadlock to all bolts.
o
Tighten included hardware to torque
specifications in bottom table unless it is
otherwise specified, factory bolts should be
torqued to factory Jeep specifications.
