Test
fi
t the motor in place. It sits above the EBB on the headstock, with its shaft
poking through and its wires (for the moment) hanging down over the EBB.
The motor is held in by four M3 (metric) screws
(part
#22
), the
black metal screws
in the kit. Put in
all four screws and tighten them well with the 5/64”
hex wrench.*
STEP 22: Installing Motor 2, the “Egg Motor”
*Purists: Unorthodox, maybe, but totally legit: 5/64” = 2 mm to within 0.001”. But you knew that, right? :)
[Ostrich EggBot Kit Assembly Guide]