STEP 11: Adding tailstock angle brackets
[Egg-Bot Kit Assembly Guide]
Add the six angle brackets to the tailstock.
They sit within the six rectangular outlines.
Each bracket is held in place by a screw from
the other side. Again, they go through the
holes with solid outlines. Tighten the screws
only just enough
to hold them in place.
Once the brackets are all in place, stand the
assembly up on end. Hold the “angled” side of each
bracket down,
fl
at against a hard surface. Then,
tighten that bracket’s screw well to hold it in place.
And, here’s how it should look when you’re done.
