[Meggy Jr RGB]
[11]
STEP 9: The Capacitors Strike Back
Add the properly bent capacitor in location
C3
.
The capacitor is larger than the outline of the drawing on the circuit
board but will still fit in place. Be sure that the negative side of the
capacitor goes to the side of the side marked “-” on the circuit board.
Push the capacitor flush to the circuit board and solder it in place.
Part
#14
is a 0.1 µF ceramic capacitor
Add five of these capacitors, in locations
C1
,
C2
,
C4
,
C5
and
C6
. (Orientation: Either
way.)
Again, the labels are tiny. If your eyes are very
good, you
might
be able to make out the
legend “104” on these.
Note:
C4 is almost underneath C3; you can
bend it out a little bit for a better fit if needed.
