Everynet CloudCell 4G, Installation Manual

Page: 4 / 28

Objectives part 1 ɉ
The purpose of this document is to provide cabling, installation, and bootup instructions of a b b b b b b b b b b b b b b b
Everynet gateway in an external or tower environment. b
Terms of use part 2 ɉ
●
Installer MUST strictly follow installation requirements as conditions of product warranty. b
●
Gateways MUST be professionally installed and it is the professional installer’s responsibility b
to make sure the gateway is properly configured and operated within local country regulatory b
requirements. b
●
There are no operator serviceable parts inside this equipment. Service MUST be provided only b
by a qualified service technician approved by gateway manufacturer. b
●
Compliance is required with respect to voltage, frequency, and current requirements indicated b
by manufacturer. Connection to a different power source than those specified may result in b
improper operation, damage to the equipment or pose a fire hazard. b
●
PoE power source must have a detachable power cord which has an integral safety ground wire b
connection to a grounded safety outlet. b
●
Do not substitute the power cord with one that is not the provided approved type. Never use b
an adapter to connect a 3-wire cable to a 2-wire outlet as this will damage the equipment. b
●
The equipment requires the use of the ground wire as a part of the safety certification. b
Modification or misuse may provide a shock hazard that could result in serious injury or death. b
●
Contact a qualified electrician or the manufacturer if there are questions about the installation b
prior to connecting the equipment. b
●
Protective earthing is provided by approved PoE adapter. Building installation shall provide b
appropriate short-circuit and GFI protection. b
●
Protective bonding must be installed in accordance with local national wiring rules and b
regulations. b
●
Surge protection and grounding should be used for all outdoor installations b
●
Equipment cabinet located on the bottom of the tower should be grounded to the grounding b
system of the tower. b
●
Shielded Category 5 (or above) cabling with drain wire and earth grounding MUST be used for b
all terminations of wired connections. b
●
Ethernet cable MUST be properly grounded through the AC ground of the PoE. bb
●
Gateway should be grounded to the grounding point on the tower. It is not permitted to ground b
a gateway directly to the tower structures. b
●
Lightning arrestor MUST be used to protect for the gateway, lighting protection should be b
grounded to the grounding point on the tower. It is not allowed to ground a lighting protector b
directly to the tower structures. b
●
All coaxial connections should be properly weatherproofed. b
●
Gateway should be attached to tower pole using metal ties. Use of plastic / nylon ties is b
prohibited. b
everynet.com 4 ɉ