get into it!
PLEASE NOTE:
The following corrective actions
may be performed by the spa owner. If the trouble
cannot be corrected in the steps below, please
contact your Everyday Hot Tubs™ dealer for
service. (Improper servicing by an unauthorized
service provider or spa owner could result in
damage not covered by the warranty and could
cause serious injury.)
EQUIPMENT WILL NOT OPERATE
• Check the control panel LCD window for
diagnostic code.
• 240V Spas: Check the circuit breaker on the
main circuit panel.
• 120V Spas: Check the GFCI power cord and
reset if necessary (see IMPORTANT SAFETY
INSTRUCTIONS at beginning of manual).
• Check the condition of the power cord.
INADEQUATE JET ACTION
• Be sure the shut-off valves are completely open.
• Open the jets by turning the jet face to allow for
maximum water flow.
• Check for obstruction or restrictions at suction
guard(s) or filters, such as leaves, etc.
NO HEAT
• Check temperature displayed in the LCD
window for desired temperature setting.
• Inspect the filter cartridge for dirt and debris.
• Check that the water is at proper level, 2/3 up
the patented Vortex skimmer opening.
• Lower ambient temperatures may result in
heat loss.
NOTE:
Do not expect instant hot water from the
jets. It will take the heater 12-24 hours to heat the
water to the temperature you desire.
LIGHT DOES NOT WORK
• Press the LIGHT pad on the control panel.
• Reposition the light bulb in the socket. (See
REPLACING LIGHT BULB.)
• Replace the light bulb with a
6 WATT BULB
(GE 918 ONLY).
troubleshooting
26
