17
Figure 18 - Pilot
LIGHTING INSTRUCTIONS
1. STOP! Read “ FOR YOUR SAFETY ” on page 16.
2. Unscrew ignitor cap and install a AAA type battery with the anode (+) pointing out. Replace cap.
3. Make sure manual shutoff valve is fully open.
4. Turn gas control knob clockwise to the "OFF" position, set the thermostat to lowest setting and turn
ON/OFF switch to OFF position.
5. Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas,
STOP! Follow "B" in the safety information label. If you don't smell gas, go to next step.
6. From "OFF" position, turn the gas control knob counterclockwise to "PILOT" position. Push in control
for 5 seconds.
7. With the control knob pushed in, push in and release the ignitor button to light the pilot.
8. Continue pushing the control knob in for a further 60 seconds to prevent the flame detector from shutting off
the gas while the probe is warming up. Release the control knob.
9. Turn gas control knob counterclockwise to the ON position.
10. This valve is equipped with a HI/ LO feature. Set fireplace input as desired.
11. If the heater will not operate, follow the instructions "To Turn Off Gas To Appliance" and call your service
technician or gas supplier.
12. Wait 30 seconds before readjusting the heater when the control knob has been turned down to a lower
setting.
TO TURN OFF GAS TO APPLIANCE
Push in gas Control Knob slightly and turn clockwise to the OFF position. Do not force.
MATCH LIGHTING INSTRUCTIONS
1. Remove any items necessary for easy access to the pilot (for example: logs, screens, etc.).
2. Follow appropriate lighting instructions found previously. Instead of pushing the
piezo button
, light a match
and hold the flame to the end of the pilot and ignite the pilot.
3.
After control knob has been released and pilot stays lit, reinstall any items that were removed for pilot ac
-
cess.
4. Call a qualified service technician for repair or replacement of the piezo ignitor.
Figure 17- Control Knob and Ignitor
Button Location
O-(With Remote Control System )
1-(Manual System ) Switch
Control Knob
Flame Knob
Electronic Piezo
