7700 MultiFrame Manual
7707OO-2-OC Telecom and Datacom Optical Wavelength Converter
Revision
1.3
Page-3
2. INSTALLATION
The 7707OO-2-OC comes with a companion rear plate that has four SC/PC (shown), ST/PC, FC/PC, or
SC/APC optical connectors. For information on mounting the rear plate and inserting the module into the
frame see the 7700FR chapter section 3.
7707OO-2-OC
LI
N
E
E
Q
U
IPM
EN
T
Figure 2-1: 7707OO-2-OC Rear Panel
OPTICAL INPUTS:
Inputs for optical signals. Available with SC/PC, ST/PC, FC/PC, SC/APC female
connectors. Accepts telecom/datacom (see specifications)
optical signals and
provides auto-rate selection and reclocking. A non-reclocking mode is also
selectable for other bi-level data formats for 125 Mb/s up to 3.187 Gb/s. These
wide range inputs accept optical wavelengths of 1270nm to 1610nm,
accommodating standard, CWDM or DWDM transmission schemes. The “LINE
IN” port is meant for the medium/long-reach fiber link connection and may be a
standard PIN or high sensitivity APD input. The “EQUIPMENT IN” port is the
short/medium reach input for the connected equipment and is a standard
sensitivity PIN input.
OPTICAL OUTPUT:
There are two SC/PC (shown), ST/PC, FC/PC or SC/APC female connectors for
optical signal outputs. The “LINE OUT” port is meant for the medium/long reach
fiber link connection and may be a 1310nm FP, 1550nm DFB, CWDM or DWDM
laser as ordered. The “EQUIPMENT OUT” port is the short/medium reach output
for the connected equipment and is a standard 1310 nm FP laser.
